Woking:
CATU Dielectric Wellington Boots
from only £96.91 Ex VAT
CATU MV-137 Class 2 20kV Dielectric Safety Boots
An electrically insulating Class 2 dielectric boot with an integral steel toe cap and vulcanized rubber sole for superior slip resistance.
- REACH Compliant
- High Voltage boot
- 200 Joule epoxy coated steel toe cap
- Fuel and oil-resistant sole
- Injection moulded using our proprietary Dielectric compound for a seamless boot with excellent electrical insulation properties
- CATU class 2 Dielectric boot provides high voltage protection of up to 20kV over the complete boot for over 8 hours
- Cleated outsole for maximum grip in wet and oily conditions (SRC)
- Provides 35kV over the sole for 3 minutes.
- Suitable for use by electricians, utility engineers and live working up to 17kV
- Available in a range of sizes
- Vulcanized rubber sole for improved slip resistance - 30% better than a conventional safety boot sole
- Energy Absorbing Heel: Provides a minimum of 20J cushioning at the heel, reducing the risk of fatigue and injury to joints and spine.
- Boot Marking: CI
- Boot Marking: E
- Machine washable at up to 40°C
- Pack size is 1 pair
- Operating voltage AC 17,000 v
- Operating voltage DC 25,500
- Class 2
- Weight 200g (each)
- Arc flash protection – Meets the requirements of ASTM F2621-2019 at 40Cal/cm²
- Energy absorbing tunnel system in the heel to EN 20345:2011 E
- Slip Resistant SRC: Tested and approved for resistance to slip on a ceramic tile floor coated with a dilute soap solution of sodium lauryl sulphate (NaLS) [SRA] and Slip resistance on steel floor with glycerol [SRB]. The tests measure forward slip on the heel and with the boot flat to the floor. Boot Marking: SRC
- Cold Insulation: The thermal insulation properties of the boot ensure that the temperature decrease inside a boot at 23°C when placed in a cold chamber at -17°C is less than 10°C after 30 minutes when measured at the upper surface of the insole.
- Heat resistant sole EN 20345:2012 HRO, 60 seconds at 300°C
